Danby DPA110DHA1CP Specifications download pdf (Page 9)

Control Buttons:

1) Power Switch

2) Mode

3) Fan Speed

4) On / Off Timer

5) Time / Temperature Set

• Used for adjusting the timer and temperature.

• The default display on control panel is room temperature.

• When key is pressed in cool mode, the set

temperature is displayed and may be adjusted. After 10 seconds the

display will revert back to room temperature.

• Timer setting is available from 1-24 hours by pressing the

key

To operate the hand held remote control you will require two “AAA”

Alkaline batteries (included).

Batteries should be replaced when:

a) No signal (beep) is heard when attempting to program the main unit.

b) The main unit does not respond to a command issued by the remote

control.

Battery replacement:

1) Slide the rear cover on the remote in the direction of the arrow.

Continue pulling (gently) until the cover separates completely from the

unit.

Notes:

1) Do not drop the remote control.

2) Do not place the remote control in a location exposed to direct sunlight.

3) The remote control should be placed about 1 meter or more away from TV, or any electrical appliances.

This Class B digital apparatus complies with canadian ICES-003.

The functions work the same as your dehumidifier’s touch controls.

Batteries: Remove the cover on the back of the remote control and insert the batteries with the (+) and (-)

poles pointing in the proper direction.

CAUTION: Use only AAA or IEC R03 1.5 V batteries.

• Remove the batteries if the remote control is not used for a month or longer.

• Do not attempt to recharge the supplied batteries.

• All batteries should be replaced at the same time.

• Do not dispose of batteries in a fire as they may explode.

PLACING BATTERIES

IN REMOTE COTROL

REMOTE CONTROL FEATURES

2) Insert (2) batteries (AAA) following the same orientation (polarity) depicted inside the battery chamber (+ / -).

3) Re-install rear cover.

4) If the remote control will not be used for extended periods of time (vacations, etc.),

batteries should be removed.

The remote operates within a range of 8 meters (26 ft.) from the receiver located inside the main unit. Any

obstruction between the receiver and remote may cause signal interference, limiting the ability to program the

unit.

www.sylvane.com 1-800-934-9194

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Comments to this Manuals

No comments

Danby DPA110DHA1CP Specifications Page 9

Comments to this Manuals

Related products and manuals for Mobile air conditioners Danby DPA110DHA1CP