Danby DOM161KBLSDD User Manual download pdf (Page 44)

INSTALLATION INSTRUCTIONS

USE TOP CABINET TEMPLATE

FOR PREPARATION OF TOP

CABINET

You need to drill holes for the top support screws, a

hole large enough for the power cord to fit through,

and a cutout large enough for the exhaust adaptor.

• Read the instructions on the TOP CABINET

TEMPLATE.

• Tape it underneath the top cabinet.

• Drill the holes, following the instructions on the TOP

CABINET TEMPLATE.

CAUTION: Wear safety goggles when drilling holes

in the cabinet bottom.

CHECK FOR PROPER

DAMPER OPERATION

Exhaust Adaptor

(absent on models shipped

for recirculation exhaust)

Blower Plate

Damper

Back of

Microwave

• Place the microwave in its upright position, with the top

of the unit facing up.

• This microwave oven may be shipped assembled for top

exhaust (adaptor installed) or for recirculation exhaust

(adaptor absent).

• Make sure tape securing damper is removed and

damper pivots easily before mounting microwave.

• You will need to make adjustments to assure proper

alignment with your house exhaust duct after the

microwave is installed.

MOUNT THE MICROWAVE

OVEN

FOR EASIER INSTALLATION AND PERSONAL

SAFETY, WE RECOMMEND THAT TWO PEOPLE

INSTALL THIS MICROWAVE OVEN.

IMPORTANT: Do not grip or use handle

during installation.

NOTE: If your cabinet is metal, use the nylon grommet

around the power cord hole to prevent cutting of the

cord.

NOTE: We recommend using filler blocks if the cabinet

front hangs below the cabinet bottom shelf.

IMPORTANT: If filler blocks are not used, case damage

may occur from overtightening screws.

NOTE: When mounting the microwave oven, thread

power cord through hole in bottom of top cabinet. Keep it

tight throughout Steps 1–3. Do not pinch cord or lift oven

by pulling cord.

1. Lift microwave, tilt it

forward, and hook slots

at back bottom edge

onto four lower tabs of

mounting plate.

2. Rotate front of oven

up against cabinet

bottom.

3. Insert a self-aligning screw through top center cabinet

hole. Temporarily secure the oven by turning the screw

at least two full turns after the threads have engaged.

(It will be completely tightened later.) Be sure to keep

power cord tight. Be careful not to pinch the cord,

especially when mounting flush to bottom of cabinet.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 76 77

Comments to this Manuals

No comments

Danby DOM161KBLSDD User Manual Page 44

Comments to this Manuals

Related products and manuals for Microwaves Danby DOM161KBLSDD