Danby DIM3225BLSST Operations Instructions Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 42
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
1
1
/2diam. hole
*If electrical out-
let is in adjacent
cabinetry.
34
3
/4 from
underside
of
countertop
to floor
Cabinets
square
and
plumb
Fig A
35 ” from
underside of
countertop to
floor.
Cabinets
square
and plumb
1 1/2” diam. hole
* If electrical outlet
is in adjacent
cabinetry.
Electrical Access
Fig.A
2
INSTALLATION INSTRUCTIONS
BEFOR USING YOUR
ICE MAKER
INSTALLATION OF YOUR
ICE MAKER
• Remove the exterior and interior packaging.
• Before connecting the Ice Maker to the power source, let
it stand upright for approximately 2 hours. This will
reduce the possibility of a malfunction in the cooling
system from handling during transportation.
• Clean the interior surface with lukewarm water using a
soft cloth.
Attach the water inlet and outlet pipe, loosen the screw
nut, choose the function switch. (see Ice Maker
performance mode instructions)
• Before first use: Please make two full boxes of ice and
then dispose it to insure the ice is clean and healthy.
• Place your Ice Maker on a floor that is strong enough to
support it when it is fully loaded. To level your Ice Maker,
adjust the front leveling leg at the bottom of the unit.
• Locate the Ice Maker away from direct sunlight and
sources of heat (stove, heater, radiator, etc.). Direct
sunlight and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may
also cause the unit not to perform properly.`
Avoid locating the unit in moist areas.
• Plug the unit into an exclusive, properly installed-
grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power
cord. Any questions concerning power and/or grounding
should be directed toward a certified electrician or an
authorized service center.
ATTENTION
• Do not open the door unless necessary.
• Should the Ice Maker be stored without use for long
periods it is suggested, after a careful cleaning, to leave
the door ajar to allow air to circulate inside the cabinet
in order to avoid possible formations of condensation,
mold or odors.
INSTALLATION
SPECIFICATIONS (BUILD-IN)
TOOLS YOU WILL NEED
FOR YOUR SAFETY:
While performing installations described in
this section, gloves, safety glasses or goggles
should be worn.
Phillips
Screwdriver
• It is recommended that you do not install the unit directly
beside a wall. This is to allow the door to have a greater
then 90° opening swing. A limited door swing may lead to
damaging the door gasket.
• The rough cabinet opening must be on a level floor
should also have a height of at least 35”.
• The electrical outlet may be positioned from within
either side of the adjacent cabinetry, or the rear of the
shaded area (as shown in Fig A).
• If the electrical outlet is located inside the adjacent
cabinetry, cut a 1-1/2” diameter hole to admit the power
cord. If the cabinet wall is metal, the hole edge must be
covered with a bushing or grommet.
15”
25"
area and at least 25” deep by 15” wide. The opening
Page view 3
1 2 3 4 5 6 7 8 9 ... 41 42

Comments to this Manuals

No comments