Danby DIM3225BLSST Operations Instructions download pdf (Page 10)

OPERATING INSTRUCTIONS

Control

Type

Condition

Function Explanation

Button Press

To turn the Ice Maker on/off

(press and hold this button

for approximately 3 seconds)

Button Press

Small amount of ice

Button Press

Medium amount of ice

Button Press

Large amount of ice

Indicator Light

FLASHING

Small amount of ice is

selected.

Water tank is full.

Medium amount of ice is

selected.

FLASHING

Large amount of ice is

selected.

Ice box is full of ice.

Indicator Light

OFF

FLASHING

Compressor works

Compressor stopped working

Stand by condition

Flashing at the same

time

Flashing at the same

time

Ice maker low on water

Sensor breakdown

FLASHING

Ice box is full of ice.

CONTROLS OF THE ICE MAKER

“Water tank is full.”

a> Please unscrew the drain cap (12) located on the back of the unit and let out the water. (Refer Page5.Fig.B)

b> After draining out all the water from the outside water tank, reconnect unit to power and it will continue to run normally.

c> If “Drain pump mode” is chosen, please confirm the “Pumped water outlet switch” is in the “ON” position. If it is in the

correct position, but still get a WARNING ALARM after you power off the unit, please contact a service center.

d> If “Manual drainage system mode” is chosen, the outside water tank will be full with water within one or two weeks

according to different ambient tempeartures, please drain out the water.

“Ice maker low on water”

a> Please check if outside water supply is functioning normally. Please see “Checking the water supply” box above.

b> The icemaker will remove faults automatically within 30 minutes and work normally when outside water pipe is

functioning.

c> Please press “ ” button and turn on the unit again if icemaker does not function normally after 30 minutes;

d> If the icemaker still shows a WARNING ALARM after the above process is repeated, please contact the service center.

“Sensor breakdown.” Please contact our authorized service center to maintain.

CHECKING THE WATER

SUPPLY

1. Turn off water supply.

2. Disconnect line from the ice

maker.

3. Position water supply line in a

bucket.

4. Turn on water and make sure

water fills in the bucket.

5. Before reconnecting the

water supply line to ice

maker, make sure the water

is turned off, then reconnect

the water supply line to the

ice maker.

* If unsure please contact

your local plumber.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Comments to this Manuals

No comments

Danby DIM3225BLSST Operations Instructions Page 10

Comments to this Manuals

Related products and manuals for Ice cube makers Danby DIM3225BLSST