Danby DAC 5209M Specifications download pdf (Page 10)

6. Installing the Slide-Out Chassis into Cabinet:

(please seek assistance for this procedure)

• Carefu]|y slide the air conditioner back into

the cabinet. (in window)

Note: Ground wire must be re-installed

before completing next step,

• Reinsta!l (slide-out-chassis) security screws

removed earlier from the (lower left/rlght) side of

the cabinet. Fig 7

• Expand the shutter frames (fuIly) on each side

and secure the top el the shutter frame to the

window sash using one 3/4" screw & flat washer

on each side_F'ig,23

• Install a shutter clamp on each side of the

(lower) shuiler frame and secure to window sill

usrng one 3/4" screw & fiat washer on each aide.

Figo23

7. Reinstalling Front Grill (All Models) :

Before re-Installing the front grill back on the

cabinet, you must re-connect the (male/female)

electrical wire harness between the front gdlt

controlpanel and the main (cabinet) unit

(Ftg,Sa) Make sure the elecldcai connection is

t_rmiyand securely attached,

• Position the front panel on the cabinet slarfing at

the top. The front panel lock tabs must be

inserted Into the retainingslols in the cabinet.

• Repeat this procedure on all sides, making sure

the fresh air ventilation lever arm and power cord

are properly installed back to their original

position on the front griilo

° Secure the front grilt Io the cabinet using the

phillips screws removed earlier. Fig's, 3 & 4

• Re-install the air filler.

_, Cut the second foam seal to fit the opening

between thelop inside and outsidewindow.

See Fig_24,

- Some installations may requireadditional sealing

around the _ndow and air conditioner, Check for

any air teaks and seat where necessary.

• Under very humidconditions, water removalmay

be excessiveenough to ovedlow from the rear of

the unit or increase noise Ievels of the air

conditioner.If thisoccurs, you may want to attach a

section of (garden) drain hose (not included) to

the drain plug located at lhe rear of the unit, thts

wtll permit condensation to run off more

conveniently. See Fig.25

Fig 7

Shutter

r-_Clamp

Fig, 23

-- 2rid Foam

Seal

Fig,, 24

j =1 H -

t'_'_,_ Dta}nHose

(nol intruded)

Fig, 25

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

Comments to this Manuals

No comments

Danby DAC 5209M Specifications Page 10

Comments to this Manuals