Danby DCR412BLLH Operations Instructions download pdf (Page 3)

INSTALLATION INSTRUCTIONS

DOOR REVERSAL

INSTRUCTIONS

Unplug the unit from the electrical outlet

(if connected) and lay it on its back:

1) Remove the screws from the upper hinge assembly

(Fig. 2).

2) Pull the door upward to remove it from the cabinet

of the Refrigerator (Fig. 2).

3) Remove the screws from the lower hinge assembly

(Fig. 4).

4) Remove the leveling leg and fixed foot located at

the bottom of the cabinet (Fig. 4).

5) Remove the plastic cap from the right side of the

door frame and reinstall it on the left side of the

door frame (the previous pin location) (Fig. 3).

6) Remove the plastic caps from the right side of the

cabinet and reinstall on the left side of the cabinet

(the previous pin location) (Fig. 1).

7) Reinstall the lower hinge assembly on the bottom

right side (Fig. 4).

8) Carefully repostion the door on the cabinet and

push down until the lower hinge pin is inserted into

the bottom of the door (Fig. 2).

9) While the door remains closed, re-install the upper

hinge assembly on the right side (Fig. 2).

10) Reinstall the leveling leg and fixed foot on the

opposite side (Fig. 4).

11) Close the door and return the unit to its upright

position (wait 60 minutes before reconnecting

power to the refrigerator); verify the door is

aligned to make a proper seal against the cabinet.

The process is now complete.

Your refrigerator has a factory-installed left-hand door swing.

To avoid personal injury to yourself and/or property, we recommend someone

assist you during the door reversal process.

1 2 3 4 5 6 7 8 ... 16 17

No comments

Danby DCR412BLLH Operations Instructions Page 3