Danby DCR032C3BSLDB Owner's Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
CLEANING
Ensure the appliance is unplugged before cleaning.
To clean the inside of the appliance, use a soft
cloth and a solution of a tablespoon of baking
soda to one quart of water or a mild soap
solution or some mild detergent.
Wash removable shelves in a mild detergent
solution, then dry and wipe with a soft cloth.
Clean the outside with a soft, damp cloth and
some mild detergent.
It is important to keep the area clean where the
door seals against the cabinet. Clean this area
with a soapy cloth. Rinse with a damp cloth and
let dry.
Note: Do not use cleaners containing ammonia or
alcohol on the appliance. Ammonia or alcohol can
damage the appearance of the appliance. Never
use any commercial or abrasive cleaners or sharp
objects on any part of the appliance.
POWER FAILURE
Most power failures are corrected within a few
hours and should not affect the temperature of your
appliance if you minimize the number of times the
door is opened. If the power is going to be off for
a longer period of time, take the proper steps to
protect your contents.
Note: Wait 3 to 5 minutes before attempting
to restart the refrigerator if operation has been
interrupted.
VACATION
• Short vacations: Leave the appliance operating
during vacations of less than three weeks.
• Long vacations: If the appliance will not be used
for several months, remove all items and turn
off the appliance. Clean and dry the interior
thoroughly. To prevent odor and mold growth,
leave the door open slightly, blocking it open if
necessary.
6
CARE & MAINTENANCE
DEFROSTING THE APPLIANCE
This appliance should be defrosted approximately
every 6 months or whenever the layer of frost in the
freezer compartment reaches 6 mm (1/4”) thick.
Remember to protect your fl oors during the
defrosting process by putting towels or a pan under
the appliance in case of leaking.
Remove all food and set the thermostat to the
“OFF” or “0” position.
Unplug the appliance and leave the door open.
After the frost has melted, discard the melted
water and leave the unit off with the door open
until the interior of the refrigerator is dry.
After defrosting is complete, set the temperature
control to maximum for 2 to 3 hours before
returning to the desired temperature setting.
Important: Never use sharp or pointed instruments
to remove ice from the freezer compartment. The
freezer compartment contains refrigerated gas
lines. If these lines are accidentally pierced it
will render the refrigerator inoperable and void
the manufacturer’s warranty. Do not allow the
refrigerator to continue operation if the freezer
compartment is pierced.
MOVING
Remove all food.
Tape down all shelves.
Turn the adjustable leg up to the base.
Tape the door shut.
Be sure the appliance remains in the upright
position during transportation. Protect the
outside of the appliance with a blanket
If the appliance is placed on its back or side
during transportation, upon reaching the
destination, allow it to remain upright for 6
hours before plugging in to avoid damage to
internal components.
DISPOSAL
This appliance may not be treated as regular
household waste, it should be taken to the
appropriate waste collection point for recycling
of electrical components. For information on local
waste collection points, contact your local waste
removal agency or government of ce.
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments