Danby DUFM505WDB User Manual download pdf (Page 5)

Electrical Requirements

Before you move your freezer into its final location, it is important

to make sure you have the proper electrical connection.

Recommended grounding method

A 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, grounded

electrical supply is required. It is recommended that a separate

circuit serving only your freezer be provided. Use an outlet that

cannot be turned off by a switch. Do not use an extension cord.

NOTE: Before performing any type of installation, cleaning, or

removing a light bulb, turn the Temperature Control to the OFF

position as shown and then disconnect the freezer from the

electrical source.

Freezer Door

TOOLS NEEDED: ⁵⁄₈" hex-head socket wrench, ¹⁄₄" hex-head

socket wrench, ¹⁄₂" hex-head socket wrench, ³⁄₈" hex-head socket

wrench, #2 Phillips screwdriver, flat-blade screwdriver, ⁵⁄₁₆" open-

end wrench, flat 2" putty knife.

IMPORTANT:

■ All graphics referenced in the following instructions are

included later in this section after “Final Steps.” The graphics

shown are for a right-hand swing door (hinges factory installed

on the right).

■ If you only want to remove and replace the door, see the

“Remove Door and Hinges” and “Replace Door and Hinges.”

■ Before you begin, turn the control OFF, and remove food and

adjustable door or utility bins from door.

Install and Remove Handle

NOTE: If reversing the door swing, move the handle from one side

of the door to the other side.

To install handle:

1. Place the handle on the door as shown. See Handle graphic.

2. Using a flat-blade screwdriver, attach the handle to the door

with the four handle screws (provided).

3. Place the trim pieces on the upper and lower handle ends as

shown.

4. Apply firm pressure with your hand on the face of the trim.

Slide the top trim down and the bottom trim up toward the

handle.

To remove handle:

1. Remove the top and bottom trim.

2. Using a flat-blade screwdriver remove the four handle screws

and lift off the handle.

Remove Door and Hinges

⁵⁄₁₆" Hex-Head Hinge Screw

1. Unplug freezer or disconnect power.

2. Open freezer door and remove base grille from the bottom

front of the freezer. See Base Grille graphic 1A.

3. Close the freezer door and keep it closed until you are ready

to lift it free from the cabinet.

NOTE: Provide additional support for the door while the

hinges are being moved. Do not depend on the door magnets

to hold the door in place while you are working.

4. Remove the parts for the top hinge as shown in Top Hinge

graphic 1B.

5. Lift the freezer door free from the lower hinge and cabinet and

set aside.

6. Remove three hex head hinge screws and bottom hinge

assembly. See Bottom Hinge graphic 1C.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

WARNING

1 2 3 4 5 6 7 8 9 10 ... 27 28

Comments to this Manuals

No comments

Danby DUFM505WDB User Manual Page 5

Comments to this Manuals

Related products and manuals for Freezers Danby DUFM505WDB