Danby DKC052BSLDB-D User Manual download pdf (Page 7)

Installation Instructions

BEFORE USING YOUR

BEER DISPENSER

 Remove the exterior and interior packing.

 Check to be sure you have all of the following parts:

 1 Safety Guard Rail

 1 Drip Tray (2 Pieces)

 1 CO2 Cylinder Support

 1 CO2 Regulator

 1 CO2 Empty Cylinder

 1 CO2 Air Line Hose (Coloured)

 1 Beer Keg Coupler

 1 Beer Tower

 1 Pull Handle (Beer Tower Faucet)

 4 Plugs: For Guard Rail Holes

 1 Metal Plate For Cabinet Bottom

 2 Steel wire shelves

 2 Steel Clamps for Coloured Hose (1 spare)

 4 Castors (2 front with locks)

 2 Metal Washers for front castors

 1 Rubber Gasket (may not be required

in all unit configurations)

 Before plugging in the keg cooler, let it stand upright for approximately 2

hours. This will reduce the possibility of a malfunction in the cooling

system from handling during transportation.

 Clean the interior surface with lukewarm water using a soft cloth.

INSTALLATION OF

BEER DISPENSER

 This appliance is designed to be free standing only, and should not be

recessed or built-in.

 Place your Beer Dispenser on a floor that is strong enough to support

the Beer Dispenser when it is fully loaded.

 Allow 3 inches of space between the back and sides of the Beer

Dispenser, which allows the proper air circulation to cool the compressor.

 Locate the Beer Dispenser away from direct sunlight and sources of heat

(stove, heater, radiator, etc.). Direct sunlight may affect the acrylic

coating and heat sources may increase electrical consumption. Extreme

cold ambient temperatures may also cause the Beer Dispenser not to

perform properly. This unit is not designed for outside installation (ie

garages, porches, etc.)

 Avoid locating the Beer Dispenser in excessive humidity.

 Plug the Beer Dispenser into a dedicated, properly installed-grounded

wall outlet. Do not under any circumstances cut or remove the third

(ground) prong from the power cord. Any questions concerning power

and or grounding should be directed toward a certified electrician or an

authorized service center.

 After plugging the appliance into a wall outlet, allow the unit to cool down

for 2-3 hours before placing any contents in the Beer Dispenser

compartment.

ELECTRICAL

CONNECTION

Improper use of the grounded plug can result in the risk of

electrical shock. If the power cord is damaged, have it replaced by

an authorized service center.

WARNING

This Beer Dispenser should be properly grounded for your safety. The

power cord of this Beer Dispenser is equipped with a three-prong plug

which mates with standard three prong wall outlets to minimize the

possibility of electrical shock.

Do not under any circumstances cut or remove the third ground prong

from the power cord supplied.

Use of extension cords is not recommended.

1 2 3 4 5 6 7 8 9 10 11 12 ... 44 45

Comments to this Manuals

No comments

Danby DKC052BSLDB-D User Manual Page 7

Comments to this Manuals

Related products and manuals for Dishwashers Danby DKC052BSLDB-D