Danby DPAC120061 User Manual download pdf (Page 11)

DRY (Dehumidifier) Operating Instructions

NOTE: During dehumidifier mode, the

exhaust hoses do not have to be vented out-

doors but should remain attached to the

unit. The drain hose must be installed

during dehumidifying mode, (see ‘Direct

Drain Instructions’ on pg. 5).

1) Press the I/O (on/off) key pad to switch on

the unit.

2) Press the MODE key until the DRY symbol

(Dehumidifying) appears in the display window.

Each depression of the MODE key will advance

to a different mode setting (Auto-Cool-Dry-Fan).

3) Press the appropriate (TEMP / TIMER ADJ) key

to select a relative humidity setting between 35%

~ 90% RH (adjustable in increments of 5%)

For continuous (non-stop) dehumidifier operation:

Press the (TEMP / TIMER ADJ) key pad until the

symbol “- - “ appears in the display window. NOTE:

The compressor will not cycle off during

“continuous” mode.

The set relative humidity level will flash in the

display window for approximately 5 seconds then

automatically revert back to display room ambient

relative humidity conditions. NOTE: The set

operating RH level must be programmed within the

5 second (flashing) condition. To view the “set”

relative humidity program any time, press either of

the TEMP/TIMER ADJ buttons.

NOTE: There is no fan speed adjustment during

dehumidifying mode (the fan speed is factory

set for “low”).

The blue (RUN) indicator light illuminates indicating

dehumidifying mode is operational (there may be a

slight delay of 10-30 seconds before the cycle

begins, this is normal).

IMPORTANT: The relative humidity setting selected

should always be set a few degrees lower than the

room ambient relative humidity conditions, to ensure

normal dehumidifying operation. NOTE: it is not

recommended to operate your Dehumidifier

below temperatures of 15.5°C (60°F) as this could

result in icing-up conditions of the evaporator coils,

and minimize efficiency.

4) During ‘Dry’ mode when the internal reservoir is

full, the unit will alarm (beep) for 20 seconds

and the water full red indicator light will

illuminate and the water full icon in the control

panel will begin to flash continuously . At this

time dehumidification will stop immediately.

However, the fan motor will continue to operate

(this is normal). To return to normal operation:

1. Switch the unit off;

2. Place a pan with a 1.9L (4 pts.) capacity

beneath the lowest drain ports located on

the

bottom rear of the unit (see Fig. D1, pg. 5);

3. Open the drains by unscrewing their drain

caps;

4. Wait until all the water inside the internal

reservoir is emptied, then reattach the drain

caps;

5. Properly dispose of the water in the pan;

6. Switch the unit on.

It may take 3-5 minutes for the compressor to

re-start. This is normal.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 40 41

Comments to this Manuals

No comments

Danby DPAC120061 User Manual Page 11

Comments to this Manuals

Related products and manuals for Dehumidifiers Danby DPAC120061