Danby ADR30B1G User Manual download pdf (Page 10)

The water tank holds accumulated condensed water, and us-

ing a safety switch, controls both the water level and opera-

tion of the dehumidi¿ cation process - i.e. when the water tank

is full and/or accidentally displaced inside the cabinet, the

À oat switch actuator (inside the tank) breaks contact with the

safety switch. This condition results in the immediate shut

down of the compressor and fan motor system, preventing

moisture from being condensed.

DEHUMIDIFYING is a means of removing moisture from the air. A dehumidi¿ er will help to protect your home and valued

possessions from damage (swelling) caused by moisture in the air. Essentially a dehumidi¿ er removes moisture from air

as moist air passes over a dehumidifying (evaporator) coil. Moisture is condensed on the evaporator coil, drained, and

collected inside an internal (removable) water tank located at the front of the unit. The exhausted air being returned into

the room environment is elevated several degrees causing the surrounding air temperature to increase (slightly). This

process also contributes to lowering the relative humidity of the surrounding air.

DEHUMIDIFYING

MODE

INSTRUCTIONS

When the unit is ¿ rst connected to the electrical outlet, the (green) power light will not light up until the “on/off” button is

pressed. When the “on/off” button is pressed, the power light turns on and the dehumidi¿ er automatically defaults to:

Display: Current Ambient Room Humidity (RH%)

Humidity Setting: 60% RH

Fan Speed: High

IMPORTANT NOTE: Depending on humidity conditions of the surrounding environment, the dehumidi¿ er may not start

automatically under the default setting (this is an indication that the humidity level of the surrounding environment is lower

than the “default” setting of 60% RH). Therefore, it may be necessary to scroll through each of the different dehumidi¿ er

settings 35% - 80% until the “humidistat” (sensor) recognizes conditions that will allow the unit to operate.

DEHUMIDIFYING MODE SELECTION:

1) The unit enters dehumidify mode when the ON/OFF button is pressed.

2a) Press the

+ / - buttons to select a desired RH operating value (35% -85%).

2b) Press the CONTINUOUS button. When CONTINUOUS mode is selected, the humidistat (sensor) will be by-passed

and the compressor will operate non-stop regardless of humidity conditions.

FAN SPEED SELECTION:

3) You can choose a fan speed (normal/turbo) using the keypad. The speed you select is identi¿ ed by the (illuminated)

indicator light located directly above the selection made.

OPERATION INSTRUCTIONS

WATER TANK

OPERATION

IMPORTANT:

Never tamper with or attempt to defeat the

water level (safety) ﬂ oat switch system. Proper

installation of the water tank is crucial to

maintaining reliable dehumidiﬁ er operation.

NOTE: On some models, the fan will continue to run for approximately 2-3 minutes after the unit has stopped

and the bucket has been removed. As a result, water may drip from the tray onto the base of the unit, and then

onto the ﬂ oor. Please ensure that you protect your wood and carpet ﬂ oors from such leakage.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Comments to this Manuals

No comments

Danby ADR30B1G User Manual Page 10

Comments to this Manuals

Related products and manuals for Dehumidifiers Danby ADR30B1G