Danby DER2099W Operations Instructions download pdf (Page 46)

L.P.

Nat.

13. Make sure Range is level

Level the range by placing a level horizontally on an oven rack. Check diagonally from front to back; then level the range by

either adjusting the leveling legs or by placing shims under the corners of the range as needed.

14. After installation is complete, make sure all controls are left in the OFF position

Model and Serial Number Location

The serial plate is located on the right-hand surface of the oven front frame at the broil drawer; or the lower panel.

When ordering parts for or making inquires about your range, always be sure to include the model and serial numbers from

the serial plate on your range.

Your serial plate also tells you the rating of burners; the type of fuel and the pressure the range was adjusted for when it left

the factory.

Gas Conversion

This range was adjusted at the factory for Natural gas as specified on the serial plate and it is equipped with fixed orifices and a

convertible appliance pressure regulator.

To convert the unit from Natural gas to LP gas will require the replacement of the orifice hoods, and adjustment of air shutters

on the burners and adjustment of the appliance pressure regulator converter cap.

Inlet pressure to the appliance pressure regulator shall be in accordance with the nominal inlet pressure of the regulator used

on the range (14 inches of water column pressure or ½ PSIG maximum) The range should be tested by pressurizing the

regulator with an inlet pressure at least 1 inch water column above the manufacture’s specified manifold pressure shown on

the serial plate, as follow:

INLET PRESSURE IN

INCHES OF WATER COLUMN

NAT

GAS

Minimum 5 11

Maximum 14 14

a. Appliance Pressure Regulator Conversion

The regulator is located at rear of the range.

• Using a screw or coin, turn the cap counterclockwise to release

from the pressure regulator. Be sure the O-ring gasket stays in

place.

• Turn the cap over and place into the slots. Turn clockwise to lock

in position. The letters corresponding with the type of gas being

used should be visible on the exposed end of the cap.

b. Orifices Conversion

To convert this unit to LP gas from Natural gas will require the

exchange of orifice hoods.

IMPORTANT: Save the orifices removed from the appliance for

future use.

1 2 ... 41 42 43 44 45 46 47

No comments

Danby DER2099W Operations Instructions Page 46