Danby SILHOUETTE DPAC120061 User Manual download pdf (Page 18)

Remote Control Operating

Instructions

1. Sending Signal: The remote control must be

aimed directly at the infra-red eye located below

control panel when initiating a command. When

the remote control is switched on and a button is

pressed, a beep will sound (main unit) confirming

a signal was sent/received. All program selections

appearing in the remote control display will appear

in the display of the main unit when both units are

operational. If the main unit does not respond to

the command issued, try the procedure again.

If the main unit again fails to respond;

Check the following:

• Are the receiver and the remote unit within the

required 7 meter (23 ft.) operating distance?

• Is the receiver window on the main unit partially

blocked and/or obscured?

• Are the batteries correctly installed inside the

remote (positive+ / negative-)?

• Check the batteries. If low, replace.

2. Setting/Adjusting Time of Day Clock

(Remote Control): When the batteries are first

installed, the clock display flashes “0:00”. Press

the M (minute) button to set the correct time in

minutes. Each time the M button is pressed the

time is increased in 10 minute increments. The

time sets automatically (stops flashing) after 5

seconds. Press/hold the H (hour) button to

select/change the correct hour time. (time flashes)

Each time the H button is pressed the time will

increase in 1 hour increments. The time

automatically sets (stops flashing) after 5 seconds.

When the main unit is swithed on using the remote

control, the time on the main unit will automatically

adjust to the time set on the remote control.

3. Mode Setting: Press the “Mode” button to select

operating mode. Each time the button is pressed

will advance to a different setting i.e

Auto–Cool–Dry–Fan.

4. Temperature Setting: Press the remote

buttons to select the desired

C/F operating temperature.

Each time a button is pressed the

temperature will increase/decrease 1°C/F. The

temperature selected will appear in the remote

display.

When the main unit is switched on using the

remote control, the temperature on the main unit

will automatically adjust to the temperature set

on the remote control. Temperature ranges from

16°C-31°C (60.8°F ~ 88°F)

5. Fan Speed Setting: Press the

“Fan” button to select the operating fan speed.

Depending on the mode selection, the fan button

will advance to a different fan speed

(Auto–Low–Medium –High)

The fan speed selected will appear in the

display window.

AN SPEED ICONS

LOW MEDIUM HIGH

MODE

AVAILABLE FAN SPEEDS

Cool Low–Medium–High

Dry Low

Fan Low-Medium-High

AUTO Low–Medium–High

Timer On/Off

LCD Window

MODE ICONS

DRY

COOL

FAN

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 40 41

Comments to this Manuals

No comments

Danby SILHOUETTE DPAC120061 User Manual Page 18

Comments to this Manuals

Related products and manuals for Conditioners Danby SILHOUETTE DPAC120061