Danby PREMIERE DPAC12010H User Manual download pdf (Page 6)

KEY PAD FUNCTIONS

POWER SWITCH: Turns unit ON/OFF

MODE: Allows you to scroll through and select

desired operating mode.

FAN: Select from three different fan settings; High,

Medium, and Low.

AUTO-TIMER

AUTO-TIMER Adjust:

Auto off- With machine in running mode, press timer

button to set timer control. Press or buttons to

select number of hours you would like the unit to run

before it automatically shuts off.

Auto on- With machine in stand by mode, press timer

button to set timer control. Press or buttons to

select number of hours before the unit automatically

starts running in air conditionning mode.

NOTE: The time is adjustable between 1-24 hours.

TEMPERATURE Adjust:

• Used for adjusting the thermostat.

• The default display is room temperature.

• In cooling mode, when button is pressed, the

set temperature is displayed and may be adjusted. After

15 seconds the display will revert back to room

temperature. Temperature is only adjustable in cool mode.

Timer & Temp. Display

Room Temp.

Temp. Set

Timer Set

MODE INDICATOR LIGHTS

Cooling Mode

When cool mode is selected, the indicator light

will shine GREEN. During the cooling mode, the

air is cooled and hot air is exhausted outside

through the exhaust tube. Adjust fan speed to suit

your desired comfort level.

Note: The air exchange h ose must vent outside

the room when using cool mode.

Dehumidify Mode

When dehumidify mode is selected, the indicator

light will shine ORANGE. Air is

dehumidified as it passes through the unit,

without being in full cooling mode. The fan will

operate on med. speed. If room temperature is

>25°C (77°F), fan speed can be adjusted;

otherwise fan speed is fixed to “low”.

Note: The warm air exchange hose must vent

inside the room when using Dehumidify Mode,

not outside as it does when cooling. If the unit is

vented outside, some cooling will occur.

Fan Mode

When fan mode is selected, the indicator will

shine YELLOW. Air is circulated throughout the

room with no cooling.

Note: The unit does not need to be vented in Fan

mode.

Heating Mode

When heating mode is selected the indicator will

shine RED. Heating is activated only when the

ambient temperature is below 25°C (77°F).

FAN SPEED INDICATOR LIGHTS

High Fan

Medium Fan

Low Fan

NOTE: By pressing both buttons at the

same time for more than 3 seconds, the display will

toggle between Celsius and Fahrenheit.

STATUS DISPLAY

Warning Light

Condensed water may accumulate in the unit. If the

internal tank becomes full, the Warning signal in the LCD

Display will light up and the unit will not operate until the

unit has been drained.

NOTE: After switching the air conditioner off, you must wait 3 minutes before switching it back on again.

OPERATION

FEATURES OF

THE CONTROL

PANEL

www.sylvane.com 1-800-934-9194

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments

Danby PREMIERE DPAC12010H User Manual Page 6

Comments to this Manuals

Related products and manuals for Conditioners Danby PREMIERE DPAC12010H