Danby DER241WC User Manual download pdf (Page 23)

INSTALLATION INSTRUCTIONS

INSTALL THE RANGE

LEVEL THE RANGE

For proper cooking and baking, the range must be

leveled. Leveling legs are located on each corner at

the base of the range.

(A) Install the oven shelves (see Using the oven

section for instructions). Put a spirit level or a glass

measuring cup partially ﬁ lled with water on one of the

oven shelves. If using a spirit level, take two readings

- with the level placed diagonally, ﬁ rst in one direction

and then the other.

(B) Turn the legs clockwise to raise the range and

counterclockwise to lower the range. Adjust the

leveling legs until the range is level.

• Check to make sure the circuit breaker is closed (RESET) or the circuit fuses are replaced.

• Be sure power is in service to the building.

• Check to be sure that all packing materials and tape have been removed. This will include tape on the metal panel

under control knobs (if applicable), adhesive tape, wire ties, cardboard and protective plastic. Failure to remove these

materials could result in damage to the appliance once the appliance has been turned on and surfaces have heated.

• Check that the door and drawer are parallel to each other and that both operate smoothly. If they do not, see the

Owner’s Manual for proper replacement.

• Check to make sure that the Anti-Tip device is securely installed.

• Be sure all range controls are in the OFF positions before leaving the range.

FINAL INSTALLATION CHECKLIST

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 76 77

No comments

Danby DER241WC User Manual Page 23