Danby DER241WC User Manual download pdf (Page 21)

INSTALLATION INSTRUCTIONS

ELECTRICAL CONNECTIONS

CAUTION

For personal safety, do not use an extension cord with this appliance. Remove house fuse or open circuit breaker

before beginning installation.

• This appliance must be supplied with the proper voltage and frequency, and connected to an individual properly

grounded branch circuit, protected by a circuit breaker or fuse having amperage as speciﬁ ed on the rating plate. The

rating plate is located under the cooktop. See the Lift-Up Cooktop section in this manual for instructions on how to lift

the cooktop.

ELECTRICAL REQUIREMENTS

Rating Plate

• We recommend you have the electrical wiring and hookup

of your range connected by a qualiﬁ ed electrician. After

installation, have the electrician show you where your main

range disconnect is located.

• Check with your local utilities for electrical codes which

apply in your area. Failure to wire your oven according to

governing codes could result in a hazardous condition. If

there are no local codes, your range must be wired and

fused to meet the requirements of the CSA Standard C22.1,

Canadian Electrical Code, Part 1 - latest edition. You can get

a copy from:

• Canadian Standards Association, 178 Rexdale Blvd.,

Toronto, ON, M9W 1R3, CANADA.

• This range is equipped with a CSA International Certiﬁ ed

Power Cord intended to be plugged into a standard 14-50R

wall receptacle. Be sure the wall receptacle is within reach of

the range’s ﬁ nal location.

ANTI-TIP BRACKET INSTALLATION INSTRUCTIONS

WARNING

Tip-Over Hazard

• A child or adult can tip the range and be killed.

• Install the anti-tip bracket to the wall or ﬂ oor.

• Engage the range to the anti-tip bracket by sliding the range back so the anti-tip

arm slides under the anti-tip bracket.

• Re-engage the anti-tip bracket if the range is moved.

• Failure to do so can result in death or serious burns to children or adults.

To reduce the RISK OF TIPPING the range, the range must be secured by a properly installed ANTI-TIP BRACKET.

Secure the bracket with the screws provided. See installation instructions for complete details before attempting to install.

NOTE: The installation of the ANTI-TIP bracket must meet all local codes for securing the appliance.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 76 77

No comments

Danby DER241WC User Manual Page 21