Danby DPAC8399 User Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
Setting the AUTO-OFF TIMER
Before setting the AUTO-OFF timer, the time of
day clock must be set/operational.
1) To set the AUTO-OFF timer, the unit must be
turned on (I/O switch) and operational.
2) Press the TIMER-OFF key pad to initiate the
AUTO-OFF time sequence. Fig. 33. The display
window will indicate TIMER-OFF and the word
OFF will flash for 5 seconds. Press the or
key pad to select the desired AUTO-OFF time.
Fig. 33a.
key pad will decrease the AUTO-TIMED
setting in 10 minute increments.
keypad will increase the AUTO-TIMED
setting in 10 minute increments.
When the desired time is established, (the time
will flash in the display window) press the
CLOCK key pad to register the AUTO TIMER-
OFF program. The word OFF will stop flashing
and remain “on” (TIMER OFF) indicating the
program is set. The time of day clock setting will
immediately revert back in the display window.
You can varify the AUTO-OFF time selection
anytime by pressing the TIMER-OFF key pad. The
time you selected will appear (flash) temporarily
(replacing the time of day) for approximately 5
seconds.
IMPORTANT: The desired AUTO-OFF time must
be registered within a 5 second period (after
pressing the TIMER-OFF key pad) otherwise the
selected time will not register and the system
will automatically revert back to the regular
“time of day” clock setting. If this occurs, you
must repeat step 2 again.
The unit will stop automatically when the specified
AUTO-OFF time is achieved on the time of day
clock. To cancel or override the AUTO-TIMED
program, simply turn off the unit manually, prior to
the scheduled AUTO-OFF time.
Fig. 33
Fig. 33a
INSTALACIÓN DEL JUEGO PARA LA
VENTANA/PUERTA DE PATIO
Su juego para la ventana ha sido diseñado para que se adapte a la
mayoría de aplicaciones estándar de ventanas verticales y
horizontales. Ahora con la adición de una tercera sección de
corredera (Fig. 2b), es posible instalar este juego en puertas de patio
(hasta una altura máxima de 80"). Consulte las figuras 2, 2a y 2b
para verificar las aberturas mínimas y máximas. Para aplicaciones de
ventanas verticales y/o puertas de patio, se suministran trabas de
posiciones múltiples en el borde de cada sección de corredera.
También se suministran dos tornillos de traba para asegurar cada
sección corrediza en la posición deseada. Figura 2c.
Opción de seguridad del tangue de
agua interno
Esta unidad viene equipada con un mecanismo conmutador de
seguridad integrada que evita que la unidad condense agua si el
tanque de agua se mueve por accidente y/o está LLENO de agua. Si
ocurre esta situación, la unidad emitirá una señal de 8 PITIDOS y la
luz indicadora de LLENO DE AGUA centelleará en color rojo
continuamente hasta que el tanque de agua se vuelva a colocar en
posición correcta y/o se vacíe.
NOTA: El motor del ventilador continuará operando en este
estado. Esto es normal, pero no habrá ni refrigeración ni
deshumidificación hasta que el tanque se vacíe y/o se instale
correctamente (podrá demorar unos minutos antes de que el
compresor regrese a su funcionamiento normal).
Ventana horizontal
Juego de corredera para la ventana
Mínimo: 26
5
/8" (67.5 cm)
Máximo: 48
3
/8" (123 cm)
Ventana
vertical
Juego de corredera para la ventana
Mínimo: 26
5
/8" (67.5 cm)
Máximo: 48
3
/8" (123 cm)
Fig. 2
Fig. 2a
Fig. 4
Puerta
de patio
Juego para puerta de patio
Mínimo: 26
5
/8" (67.5 cm)
Máximo: 80" (203 cm)
Fig. 2b
Fig. 2c
Instrucciones de operación
Antes de encender esta unidad
1) Seleccione un lugar adecuado, asegurándose de que tenga un
acceso fácil a un tomacorriente.
2) Instale la Manguera flexible de escape y el Juego graduable
de corredera para la ventana según se ilustra en las figuras
2, 2a y 2b
NOTA: El segundo paso se requiere solamente cuando se usa el
MODO DE AIRE ACONDICIONADO.
3) Enchufe la unidad en un tomacorriente con conexión a tierra de
115 V/60 Hz. NO USE UN CABLE DE ALARGAMIENTO
REGULAR CON ESTAUNIDAD.
Si es necesario usar un cable de alargamiento para conectar su
acondicionador de aire use un cable de alargamiento aprobado
específicamente para un acondicionador de aire (disponible en
cualquier tienda de ferretería local).
4) Asegúrese de que el Tanque de agua esté en posición correcta
dentro del armario ya que, de otra forma, la unidad no funcionará.
Figura 4.
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Comments to this Manuals

No comments