Danby ADR3006 User Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
Circuit d’alimentation électrique - Spécifications
1. Tout câblage doit être réalisé par un électricien
qualifié, en conformité avec les prescriptions des
codes national et local régissant les installations
électriques. Pour toute question au sujet des
instructions qui suivent, contacter un électricien
qualifié.
2. AVANT l’installation et AVANT l’utilisation de cet
appareil, contrôler les caractéristiques de la source
d’électricité, et résoudre tout problème affectant le
câblage.
3. Pour la sécurité et la protection des utilisateurs, cet
appareil est relié à la terre lorsqu’il est branché sur
une prise de courant de même configuration que la
fiche de branchement. En cas de doute quant à la
qualité de la liaison à la terre de la prise de courant,
consulter un électricien qualifié. NE JAMAIS
UTILISER UN CÂBLE DE RALLONGE NI UN
ADAPTATEUR SI LA CONFIGURATION DE LA
FICHE DE BRANCHEMENT NE CORRESPOND PAS
À CELLE DE LA PRISE DE COURANT.
4. La plaque signalétique de l’appareil est située sur la
paroi arrière du compartiment du réceptacle à eau; on
y trouve les caractéristiques électriques et techniques
spécifiques de cet appareil.
5. Pour éviter les risques de dommage corporel, on doit
toujours débrancher l’appareil de la source d’électricité
avant d’entreprendre des travaux de nettoyage ou
d’entretien.
16
Capacité de déshumidification (Pintes/Litres) 30 / 14.2 40 /18.8
Alimentation électrique 115 Volts / 60 Hz
Consommation d’énergie (watts) 490 560
Demande de courant nominale
• Déshumidification 4.5 5.2
Débit de circulation d’air maxi (pieds cubes par minute) 118 124
Type de réfrigérant R22 R22
Capacité du réceptacle à eau (litres) 5 / 10.55 5 / 10.55
Niveau de bruit en fonctionnement (dB A) 50 50
Dimensions (largeur/hauteur/profondeur) 13-3/8 x 19-15/16 x 10
Poids net (kg/lb) 14.5/32 15 / 33
NOTE: Les spécifications sont sujettes à modification sans préavis (pour l'amélioration des produits).
Spécifications de l’appareil:
ADR3006 ADR4066
9
Operating Instructions:
Dehumidifying is a means of removing moisture from the
air. A dehumidifier will help to protect your home and
valued possessions from damage (swelling) caused by
moisture in the air. Essentially a dehumidifier removes
moisture from the air, as moist air passes over a
dehumidifying (evaporator) coil. Moisture is condensed on
the evaporator coil, drained and collected inside
an internal (removable) water tank located at the front of
the unit. The exhausted air being returned into the room
environment is elevated several degrees causing the
surrounding air temperature to increase (slightly). This
process also contributes to lowering the relative humidity
of the surrounding air.
Dehumidifying Mode Instructions:
When the unit is first connected to the electrical outlet,
the (green) power light starts to flash and continues to
flash until the “on/off” button is pressed. When the “on/off”
button is activated, (pressed) the flashing (power) light
turns to a steady state “on” condition and the dehumidifier
automatically defaults to;
Display: Current Ambient Room Humidity (RH%)
Humidity Setting: 60% RH
Fan Speed: = Low
IMPORTANT NOTE: Depending on humidity conditions of
the surrounding environment, the dehumidifier may not
start automatically under the default setting. (this is an
indication the humidity level of the surrounding
environment is lower than the “default setting of 60% RH)
Therefore, it may be necessary to scroll through each of
the different dehumidifier settings 35% ~ 80% until the
“humidistat” (sensor) recognizes conditions that will allow
the unit to operate.
DEHUMIDIFYING MODE SELECTION:
1. To turn the unit on press the ON/OFF button.
2. Press the humidity “UP” or “DOWN” button to select a
desired RH operating value. (35% ~ 80%)
-OR-
2a. Press the CONT. button. When CONTINUOUS mode
is selected, the humidistat (control) will be by-passed
and the compressor will operate non-stop regardless
of humidity conditions.
FAN SPEED SELECTION:
3. Select a fan speed on the keypad. The speed
you select is identified by the (illuminated) indicator
light located directly above the selection made.
AIR FILTER:
Your dehumidifier features a removable Air Filter. This
filter is located at the front of the unit (behind the air intake
grill) directly above the water tank compartment.
The air filter plays an important role in helping to reduce
(minimize) dust/dirt particles from the surrounding
environment. A blocked/clogged air filter reduces air
intake, impacting negatively on operating efficiency.
To maintain maximum operating efficiency;
The filter must be checked and cleaned regularly. (every 2
weeks)
More frequent cleaning may be required depending upon
indoor air quality.
IMPORTANT: Never operate the unit without the air filter
in place.
AIR FILTER REMOVAL:
1. Grasp the filter handle, and pull the filter out. The filter
will slide out easily. See Fig.2
2. Clean the filter thoroughly using vacuum a cleaner or
wash using luke warm water and mild detergent.
Dry thoroughly before re-installing.
3. To re-install the air filter, slide the filter back inside the
tracks and push inward.
Operating Instructions
Fig. 2
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments